Solar water pump installation in Norway

How do you design a solar water pumping system?

When designing a solar pumping system, the designer must match the individual components together. A solar water pumping system consists of three major components: the solar array, pump controller and electric water pump (motor and pump) as shown in Figure 1.

How to choose a solar water pumping system?

The type of solar water pumping system: borehole/well (submerged), floating or surface will depend on the water source. If the source is a borehole (proposed or existing) or deep well, then a submersible pump that fits the borehole or well should be selected. If the water source is a river, then a surface pump should usually be selected.

What are the components of a solar water pumping system?

A solar water pumping system consists of three major components: the solar array, pump controller and electric water pump (motor and pump) as shown in Figure 1. Note: Motor and pump are typically directly connected by one shaft and viewed as one unit, however occasionally belts or gears may be used to interconnect the two shafts.

Where is a solar water pump located?

In these systems the solar water pump is located within the borehole or well. These pumps are generally available for 100 mm (4 inch) and 150 mm (6 inch) boreholes. The solar array is typically located near the top of the borehole/well and the water is generally pumped to a storage tank. The pump controller is typically located at the solar array.